|
|
LCD Dash Functions
- Resetting the service light
- Key On
- Press Lap and R for 5 seconds
-
- Switching KM/H to MPH
- Key on
- Press A about 5 seconds until speedometer LCD blinks
- Press B to change unit of measurement
- Press A for 5 seconds to confirm choice
-
- V Max
- Uses trip odometer #1 (the odometer
displayed during instantaneous speed)
- To reset trip odometer #1 press R
for 2 seconds
- To display V max and distance of trip
odometer 1 press B for 2 seconds
- To reset V max press R for 2 seconds
-
- AVS (Average Speed)
- Uses trip odometer #2
- Hold down B for 2 seconds and then press again
- AVS is displayed along with distance of trip odometer #2
- To reset both AVS and trip odometer #2 press R
for 2 seconds
-
- Redline threshold (Can be set only when engine off)
- Press C, release, and press again
- Release C when desired RPM is reached
-
- Battery voltage
- Press D once
-
- Setting Time of Day Clock Hour
- Press D twice
- Press LAP until desired hour is reached
- Press D to confirm
-
- Setting Time of Day Clock Minute
- Press D three times
- Press LAP until desired minutes is reached
- Press D to confirm
-
- Setting °C or °F
- Press D four times
- Press LAP to alternate units
-
- Chronometer (Lap Timer)
- V max, AVS, and trip odometer #2 no longer function
in this mode
- Press LAP and within 0.7 seconds press D
to enter chronometer mode
- To start timing press LAP and release immediately
- To store a lap time press LAP
- To display lap times press B
- To cycle through the stored laps, press LAP
- To reset memory press A and LAP for 2 seconds
- To leave chronometer function press LAP and D
-
Aprilia and logo are registered trademarks of Aprilia, S.p.A., Italy. See Legal disclaimer.
|